This section is a continuation of the example with an added feature of the device sweep.
You will see a list of circuit variables that can be displayed.
You should be able to see the transient current response for the three different Resistors sweep values.Use of the.step Command, the.step statement performs a parametric sweep to be performed on a specified variable. model name model variable model parameters (line value).model rmod RES(R1 in the statement above, a model type and a model name followed by a model parameter name in parenthesis.By default, the data file created by PSpice is a binary data file;.e., you can't read it with a text editor.DC command, the.DC command causes the DC sweep analysis to be performed on the circuit.The second example shows the sweep of the capacitor value of the second-order high pass filter circuit.08/07/04 14:23: Evaluation PSpice (Nov 1999) RES_tran Rp 0 1 rmod.model rmod RES(R1).step RES rmod(R) 1,5,2 Lp 1 0 8mH IC20A Cp 1 0 10mF IC0V.tran 500US 100MS 0S 500US UIC.probe.END * Resistor model parameters rmod R 1 JOB concluded total JOB time.13 For meaningful information about the transient response we need to use another program that is bundled with PSpice.Second order high pass filter Vs 1 0 AC 10V 0 Rf 1 2 rmod.model rmod RES(R4).step RES rmod(R) 4, 8, 2 Cf 2 3 2uF Lf 3 0 127uH.AC DEC 20 100Hz little debbie valentine giveaway 1MEG.probe.END This time also we did not use 1V for the input voltage.If we create a circuit listing named "R" containing a ".tran" statement and a ".probe" statement, PSpice will create a file named "circuit1.DAT" holding the data as well as the usual "circuit1.OUT" file with basic information about the circuit. .We show this gain in decibels.The idea is to sweep the devices using the.step command, and study the AC response.
Each of the curves above represents the three Resistor values specified in the.step statement.
One or more sweep variables are varied over a specific disney world sweepstakes one more day range for specific points.
In Probe, click on the V1 at the lower left corner and then hit the "Delete" key.
print step value final time print delay Max step.tran 500us 100ms 0s 500us UIC.
You can launch Probe from the Start menu of Windows, but you will then need to go to Probe's File menu and open the DAT file you want to see.This time choose I(L) and click "OK".Since PSpice automatically adjusts its time step size during the simulation, it may increase the step size to a value greater than desirable for displaying the data. .Back to Main Page.print delay is the print delay time this specified value is the no-print value and the results from this value are not plotted, printed, or given to probe.